HOME > PRODUCTS > AMPLIFICATION > PRE AMPLIFIERS > LUXMAN > C-1000F
C-1000f
Luxman C-1000f Pre Amplifier
Since 1925, Luxman are not about mass produced products designed in Japan, then assembled in China from generic parts. Rather Luxman are designed in Japan, then each part is carefully tested & evaluated. Many parts are custom made for them which really does make these designs special.
Apart from the shared Power Supply, the amplifier designs are usually dual mono. Even the transformers are made in Japan to their specification. Luxman select the color paint used on the resistors (to identify value & tolerance) based on extensive listening tests.
The chassis is carefully tuned, both vibration and resonance are carefully controlled; they perform like a musical instrument. Finally assembly & testing is all carried out in Japan.
The Japanese attention to detail is fantastic, the amplifiers come wrapped in a cloth shroud with elastic underneath, all of the RCA & XLR sockets are protected from oxidation with individual plastic sleeves. Even the power cord is a cut above the normal give-away and actually sounds good. No wonder Luxman achieve a superior sound.
Manufacturers website here
Review 1 Luxman C-1000f PDF Download here
Luxman C-1000f Pre Amplifier
Specifications:
Input sensitivity/
Input impedance
Unbalanced (LINE 1~3)
Balanced (BAL 1~3)
333mV/51KΩ
333mV/102KΩ
Output voltage/
Output impedance
Unbalanced
Balanced
Rated 1V/210Ω maximum 4.5V
Rated 1V/420Ω maximum 9.0V
Total harmonic distortion
Unbalanced
Balanced
0.0016% (1KHz)
0.0007% (1KHz)
Frequency Response
20Hz~20kHz
10Hz~116KHz
+0 and -0.1dB
+0 and -3.0dB
Signal-to-Noise Ratio
Unbalanced
Balanced
124dB (1kHz (IHF-A))
128dB (1kHz (IHF-A))
Input
Unbalanced RCA (LINE 1~3)
Balanced (BAL 1~3)
3 systems each
Output
Unbalanced RCA
Balanced
2 systems each
Attachment
Front panel
Operation switch and power indicator
Input selector and volume
Dot matrix FL display
Output mode indicator
Balance phase change indicator
Rear panel
Main power switch
Signal ground terminal
Remote output
Line phase sensor
AC inlet
Remote control functions
Operation and input selector, volume up /down, mute
Output mode, balance, phase change and dimmer
Channel pre-setting, relative gain and input assignation.
Accessories
Remote control, mains cable, cable for remote control (JPA-20000), & Owner’s Manual
Power supply voltage
AC115V (50/60Hz)
Electric power consumption
28W (operating), 2.3W (stand-by)
Dimensions
440 (W) ×134 (H) ×429(D) mm
Weight
51 lbs. (NET)
