The Violectric DHA V590 2 is the new top device in the Violectric range. It has a state-of-the-art D / A converter and a headphone amplifier.

The D / A converter is a new development with the ESS-Tech ES9026 PRO converter. This 32-bit converter contains 4 parallel D / A converters per channel and offers a dynamic range of 124 dB with a THD + N of -110 dB. The latest findings from the multiple test winners from Violectric and Niimbus have been implemented in the headphone amplifier.

Most of the functions can be conveniently controlled using a remote control. The Violectric DHA V590 2 provides an unrivaled technology not only one of the most powerful headphone amplifier on the market, but also:

LOWEST NOISE - through a very small amount of internal gain. This makes the amplifier's self-generated noise inaudible

HIGH OUTPUT VOLTAGE - through 50 V internal operating voltage. Therefor ideally suited for high-impedance headphones deserving high output voltage swing.

HIGH OUTPUT POWER - thanks to powerful amplifiers that offer far more power even the most demanding headphones would need. So best suited for headphones with low impedances as well as magnetostatic headphones !!

HIGH ATTENUATION FACTOR - due to lowest thanks to the lowest output impedance. Therefore ideally suited to control even the most difficult headphones without influencing them with a guarantee for an uncompromising frequency response.

Features

• Remote control for volume, mute, input selection, resampling, output selection
• A motorized volume control and a balance control
• 3 analog stereo inputs, 2 x unsym. via cinch, 1 x balanced via XLR
• 4 digital inputs, bal, coax, opto with up to 24 bit and 192 kHz, USB with up to 32 bit and 384 kHz for PCM signals, DSD 64 - 256
• 4 x 32 bit converter per channel with -110 dB THD + N and 124 dB dynamic
• +/- 18 dB pre-gain for optimal adaptation of the DHA V590 to the source and headphones
• 4 powerful amplifiers, 6400 mW Pmax at 50 ohms, 21 V RMS at 600 ohms
• Monitoring of the headphone outputs for DC voltage and overload
• Headphone path and line-out path can be switched separately
• Headphone outputs: 1 x 4-pin XLR, balanced / 1 x Pentaconn, balanced / 1 x 6.3 mm jack, unbal.
• Line outputs, stereo: 1 x bal. Via XLR and 1 x unbal. via cinch
• Adaptation of the line-out signal to the following devices in the range of +/- 18 dB
• 2 toroidal transformers,> 35,000 uF filter capacity

The choice is yours:
headphone amplifier? Preamp? D / A converter? Combination? Everything goes!
The headphone outputs or the rear line outputs can be activated / deactivated using a switch on the front.

Remote control Control
the Violectric DHA V590 2 from a distance with its elegant remote control milled from solid. Infrared gives you access to the motorized volume control, mute, input selection, resampling settings, headphone and line-out control.